I have created an array of table plan mounts for you to print off, to make your table plans look that little bit more special. The mounts are listed under 'Table Plan Mounts' on this site.
To make your 3D table Plan just follow the following simple steps:-
Materials needed
Card
Sticky pads (available from most craft supplies and stationers)
A back board to attach your table plan to ( this need to be quite stiff so as not to bend) coloured boards are available from most craft shops
Step 1
Purchase some card in the colour of your choice, load it into your printer and print the mounts you require for the number of tables you have. The mounts are pre sized and should accommodate up to 10 guests.
Step 2
Cut out each mount, do not cut out the centre blank as this will be where your guests names will be glued to.
Step 3
Type up each table on your PC in a script of your choice and cut out the table name in an oblong which is exactly the size of the 'blank' in the centre of the mount.
Do this for all your tables.
Step 4
Place a sticky foam pad approx. 5mm from each edge of the back of each tables names and in the centre and attach it to the blank in the centre of the mount. You should now have a 3D table of names.
Do this for all your tables
Step 5
Place sticky pads on the back of the printed mount in the same way as you added the guests names, position and attach to the back board.
Step 6
Attach any embellishments i.e. padded hearts, butterflies etc to make your table plan look amazing
Hey presto, you've made a stunning table plan for your wedding
No comments:
Post a Comment